Description: |
- Most preferred method to keep HS4 control units and power supply
organized and secured in a single location
- Enclosure and mounting backplane (included) and 1 or 2 HS4 control units
(not included)
- Removable backplane allows the installer to configure, layout and test prior
to on-site installation
- Includes power supply, voltage regulator, dual input power distribution
module, and access power controller |
|
|
4-Door HS4 Power Supply Enclosure
HS4 Power Supplies
Amperage: |
- 6 AMP power supply
|
Power Supply
2-679-0994: |
- UL Listed Sub-Assembly power supply/charger converts a 120VAC, 60Hz
input into a single 12VDC or 24VDC output
- Fire alarm disconnect
- Overvoltage protection
- Low power disconnect (prevents deep discharge of stand-by batteries)
|
Voltage Regulator
2-679-0999: |
- Voltage Regulator converts a 24VDC input into a regulated 5VDC or
12VDC selectable output at up to 6A supply current
- Reduces the cost of adding an additional power supply to achieve 24VDC
and 12VDC or 5VDC simultaneously
|
Dual Input Power
Distribution Module
2-679-1100: |
- Designed to steer the power from either two (2) low voltage AC or DC
power sources
- Power is distributed over a total of eight (8) fused protected outputs
|
Access Power Controller
2-679-0997: |
- Converts one (1) 12 to 24 VAC or VDC input into four (4) independently
controlled fuse protected outputs
- Power outputs can be converted to dry form “C” contacts
- Outputs are activated by an open collector sink or normally open
(NO) dry trigger input from an Access Control System, Card Reader,
Keypad, Push Button, PIR, etc., and will route power to a variety of
access control hardware devices including Mag Locks, Electric
Strikes, Magnetic Door Holders, etc.
- FACP Interface enables Emergency Egress, Alarm Monitoring, or may be
used to trigger other auxiliary devices. The fire alarm disconnect
feature is individually selected for any or all of the four (4) outputs
|
Enclosure & Environmental: |
- Wall mount for indoor use
- Operating temperature: 32°F to 120°F
- Storage temperature: -4°F to 158°F
- 16 AWB powder-coated steel enclosure
- Single 1.5" center knockout on the top of the enclosure
- Nine (9) two-stage knockouts for 0.75" or 1" conduit
- 14.5" (W) x 18" (H) x 4.62" (D)
- Approximate weight: 15.5 lbs.
|
Included Contents: |
- Enclosure
- Power supply
- Voltage regulator
- Dual input power distribution module
- Access power controller
- Removable mounting backplane
- One (1) cam lock
- One (1) Tamper switch
- Mounting hardware
|
Certifications: |
- CE approved
- UL294 Listed - Access Control System Units
|
Warranty: |
- One (1) year
|
Notes: |
- Control Units not included. |
|
|
Description | File Number |
HS4 Access Power Controllers Installation Instructions | Please login to view document |
HS4 Voltage Regulator Installation Instructions | Please login to view document |
HS4 Dual Output Power Distribution Installation Instructions | Please login to view document |
HS4 Power Supply/Charges Installation Instructions | Please login to view document |
HS4 Trove Power Supply Kits Installation Instructions | Please login to view document |